Row 1:

Start at the top left-hand corner position by placing the first panel with the 3 'end' lugs pointing to the left.

Then fit a second panel with the 3 end lugs pointing to the right

Continue to lay the row with as many full panels as required for the size of the floor, all with the 3 end lugs pointing right. Make sure that the panels are flush along the whole of the length of the row to ensure the edging will be straight.

After completing the first row of panels fit the edging to this row before commencing to lay the second row. (See below for 'edging laying' instruction)

To fit the panels

Hold the panel at an angle as shown and push it so that the lugs slide underneath the panels already laid. When the lugs are fully under, and the two panels are fully touching all along their edges, then lower the panel to the floor.

It may be helpful to have someone to hold the panels of the first row whilst fitting the second row, to stop them slipping on a smooth or carpeted surface.

If the panels are not square, or if the edges are not touching along the full length, the panel being fitted will not lower.

Do not force the panel down,

Simply adjust until it lowers.

Continue to lay the row with as many full panels as required for the size of the floor, all with the 3 end lugs pointing right. Make sure that the panels are flush along the whole of the length of the row to ensure the edging will be straight.

After completing the first row of panels fit the edging to this row before commencing to lay the second row. (See below for 'edging laying' instruction)

Row 2:

Begin row 2 at the left-hand side with half a panel, again with the 3 end lugs pointing left as it is the first panel in the row. Then fit full panels with the 3 end lugs all pointing right, and complete the row with another half panel.

Half length and full length edges are supplied so that the panel joints and the edging joints never coincide, i.e they follow the same overlapping brickwork pattern. NB: The corners are always positioned on the sides of the floor as shown below and never on the top (i.e of row 1)

Row 3:

Lay with full panels as row one.

Row 4:

Start and finish with half panels as row two.

Continue alternating rows and fitting edges as above until the floor is laid.

PLEASE NOTE:

1) Never move trolley without the removable top bar fitted.

2) The flooring being made from natural wood, should be stored in a well ventilated atmosphere, and never in a hot, dry place.

3) Avoid excessive exposure to moisture.